User's Manual
Table Of Contents
- Introduction
- Supported card technologies
- Mounting the Terminal
- Drilling the back casing
- Wiring the Terminal
- Fail safe lock
- Fail secure lock
- External power
- Internal power
- Power connections
- Input configuration
- Inputs not in use
- Ethernet cable ferrite
- Power connections
- Typical Wiegand read head wiring
- Input configuration
- Inputs not in use
- Ethernet cable ferrite
- Terminal Network Configuration
- Using the Terminal
- Diagnostics and Testing
- Network
- Versions
- Database
- Configuration
- Unit information
- Input tests
- Network tests
emerald Quick Installation Guide
25
4.2.2 Network routing - (advanced users)
The emerald terminal needs to be able to communicate with the Central Database Computer
(CDC) and the Real Time Computer (RTC). If a network is fragmented, and the terminal, CDC
and RTC are on different parts of the network it may be necessary to route communications to
the RTC. In this situation contact the site network administrator.
4.2.3 Testing the connection with the AC2000 server
The terminal can be used to test the connectivity with the AC2000 server via a PING utility.
1. From the Configuration Menu press Tests | Network tests
2. Press the Ping address field below Ping any.
Figure 22 Testing the connection with the AC2000 server
3. Type the IP address of the AC2000 server (CDC/RTC) and press OK.
4. Press Ping any.
i. If a response is received from the pinged address the Ping any button will turn green.
ii. If no response is received from the address the Ping any button will turn red.
5. The PING utility can be used to check connectivity to any device on the network.
Figure 21 The routing menu
1. From the Configuration Menu press
Device Settings | Routing.
2. Press the Network field, type the
network IP address and touch OK.
3. Press the SubNet mask field, type the
address and touch OK.
4. Press the Gateway field, type the
address and press OK.
5. Touch Done to close the menu.