User's Manual
Table Of Contents
- Introduction
- Supported card technologies
- Mounting the Terminal
- Drilling the back casing
- Wiring the Terminal
- Fail safe lock
- Fail secure lock
- External power
- Internal power
- Power connections
- Input configuration
- Inputs not in use
- Ethernet cable ferrite
- Power connections
- Typical Wiegand read head wiring
- Input configuration
- Inputs not in use
- Ethernet cable ferrite
- Terminal Network Configuration
- Using the Terminal
- Diagnostics and Testing
- Network
- Versions
- Database
- Configuration
- Unit information
- Input tests
- Network tests
23
Chapter 4
Terminal Network Configuration
The network settings are accessed via the installer configuration menu on the terminal.
4.1 Checking emerald’s Network Status
1. Tap the Reader Address icon. The network status indicator is displayed on screen for
eight seconds.
Figure 17 Checking the network status
Each section of the status indicator represents a different aspect of the network connectivity.
The presence or absence of a block indicates whether or not the connection is good.
Figure 18 The network status indicator
Network status indicator
The top block indicates that
the terminal has received its
onboard database of
cardholders/timezones etc.
The centre block indicates
that the terminal has received
its configuration settings from
the CDC
The bottom block indicates
that the terminal is connected
with the RTC.
The TCP/IP indicator shows
Ethernet connectivity.