User's Manual
Table Of Contents
- Introduction
- Supported card technologies
- Mounting the Terminal
- Drilling the back casing
- Wiring the Terminal
- Fail safe lock
- Fail secure lock
- External power
- Internal power
- Power connections
- Input configuration
- Inputs not in use
- Ethernet cable ferrite
- Power connections
- Typical Wiegand read head wiring
- Input configuration
- Inputs not in use
- Ethernet cable ferrite
- Terminal Network Configuration
- Using the Terminal
- Diagnostics and Testing
- Network
- Versions
- Database
- Configuration
- Unit information
- Input tests
- Network tests
TSR-UL-0061-1.3
22
3. Attach the front of the terminal to the back casing and fix in places with the screws.
4. Attach the side panels to the terminal.
Note
If the terminal needs to be open after installation, the side panels can be removed by inserting
a 5 mm (0.2”) flat head screwdriver into the slot under the centre of the panel and sliding along
the length of the panel.