User's Manual

ManualsBrandsControlled Electronic Management Systems ManualsElectronicsemerald V9.3 multi smart card reader

Table Of Contents

Introduction
- 1.1 Terminal specifications
  - 1.1.1 CEM emerald product codes
Supported card technologies
- 1.1.2 UL-294 grading
- 1.1.3 Terminal dimensions
- 1.1.4 Part ratings
- 1.1.5 emerald terminal key components
- 1.2 Simplified AC2000 Network Topology
- 1.3 Hardware Installation Process
Mounting the Terminal
- 2.1 Preparing for mounting
Drilling the back casing
Wiring the Terminal
- 3.1 Cabling requirements
  - 3.1.1 Ethernet host
- 3.2 The Main Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
  - 3.4.1 Wiring a voltage provided lock (internal power)
Fail safe lock
Fail secure lock
- 3.4.2 Wiring a voltage not provided lock (external power)
- 3.4.3 Output power switch
External power
Internal power
- 3.4.4 Supported third party read heads
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
Power connections
Input configuration
Inputs not in use
Ethernet cable ferrite
- 3.7 Terminal with Third Party Wiegand Read Head
- 3.8 Configuration information
Power connections
Typical Wiegand read head wiring
Input configuration
Inputs not in use
Ethernet cable ferrite
- 3.9 Tamper Detection on Terminal Inputs
  - 3.9.1 Wiring the resistor network
  - 3.9.2 Re-assembling the terminal
Terminal Network Configuration
- 4.1 Checking emerald’s Network Status
- 4.2 Accessing the System Configuration Menu
Using the Terminal
- 5.1 Presenting your card
Diagnostics and Testing
- 6.1 Navigating the Menus
- 6.2 Accessing the System Configuration Menu
  - 6.2.1 System Information menu
Network
Versions
Database
Configuration
Unit information
- 6.2.2 Tests menu
Input tests
Network tests
- 6.3 Maintenance

TSR-UL-0061-1.3

CHAPTER 1 : Introduction

1.2 Simplified AC2000 Network Topology

Figure 4 Basic illustration of a typical AC2000 network including emerald configurations

Important

The emerald terminal is only available as an ethernet device.