User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
A2SE67-UG-0011-1
User Defined Logo
90
22. Click SEND.
Figure 90 Confirming logo is ready to be displayed on the emerald terminal
23. Click OK when the confirmation prompt is displayed (See Figure 90). This displays a
confirmation message that the image has been sent to all emerald readers on the system.
Note
The logo will only update on each reader, following a car swipe.
The uploaded logo will replace the existing logo on the dancing card display on the emerald
terminal. To add an additional logo, click ANOTHER.
Add additional logo