User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
emerald TS100/200/300 Installation Manual
87
Appendix F: User Defined Logo
The Card Logo function is used to display a user defined logo on the emerald terminal. This logo
replaces the default CEM logo that appears on the dancing card on the main emerald screen.
Figure 83 Replacing existing dancing card logo with a user defined logo
To display a Card Logo on the emerald terminal, it must be uploaded using AC2000 WEB.
Licensing the emerald logo change function
1. Log into AC2000 Web.
2. Navigate to AC2000 Setup | Licensing.
Figure 84 Licensing code entry field
Note
If you do not have a license, contact CEM quoting your System ID number to receive a
emerald logo change license code.The System ID is displayed at the top right of the
Licensing application interface. (See
Figure 85)
3. In the Licensing application, type the four part license code and click Add.
4. Once the license code has been applied, scroll the list of licenses to check that ‘Yes’ is
displayed beside the emerald Logo Change option.
Figure 85 emerald Logo Change license added to the CDC
Existing logo
on dancing
card
User defined
logo on
dancing card
emerald Logo
Change license
added
successfully
System ID