User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
TSR-IM-0045-1.6
78
Slave settings
Toggle settings for any connected slave devices.
indicates that the setting is enabled
X indicates that the setting is disabled
Figure 75 Configuring the slave settings
Door mode
The door mode option is used to toggle between the available door modes:
• Door mode
• Control post
• Passenger mode
indicates that door setting mode is enabled
X indicates that door setting mode is disabled
Figure 76 Configuring the door mode setting
Remote Applications
The Remote Applications option is used to enable/disable Remote Application functionality for
the terminal.
indicates that the setting is enabled
X indicates that the setting is disabled
Figure 77 Configuring the remote applications setting
Tap to enable/disable
slave settings
Tap to enable/disable the
keypad the S610s slave
Tap to enable/disable an
attached S610s slave
Tap to enable/disable
an attached DIU
Tap to use the slave as
the master reader
Tap to save changed settings
Currently configured
door mode
Tap to enable/disable door
mode settings
Use the arrows to scroll
through available door modes
Tap to enable/disable Remote
Applications settings
Tap to enable/disable
Remote Applications on
the terminal