User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
emerald TS100/200/300 Installation Manual
75
Appendix II: Device Settings Remote
Application
The Device Settings Remote Application is used to adjust specific terminal settings that would
ordinarily be carried out in the Devices application of AC2000.
Note
For information about configuring Remote Applications see the emerald User Guide.
Using the Application
1. Using a card which has the relevant permissions to access the Device Settings Remote
Application, press the Remote Applications icon and swipe the card when requested.
2. Press the Device Settings icon to open the application.
The configurable options are displayed in a two page list. The user can navigate between
pages by tapping the Next page or Previous page buttons. The number of pages in the list
are indicated by the number of dots between the Next page and Previous page buttons. The
filled dot represents the one currently in view on the screen.
Figure 68 The device settings remote application
3. Tap the option to be adjusted to open settings editor mode
4. Configure the settings as required (See Configuring the options).
5. Press the Save button to save changes made to each setting.
Note
In settings editor mode, a Save changes button is displayed at the top of the screen and the
symbol on the back button becomes red to indicate that going back without pressing Save
changes will cause any changes made to be lost.
Previous
page
button
Next
page
button
Page navigation
indicator
Back button
Tap any row
to edit