User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
emerald TS100/200/300 Installation Manual
73
Appendix I: Updating Firmware
Updating the emerald terminal firmware (device defrosting) is accomplished by using the AC2000 web
pages to load the firmware pack on to the terminal and then manually updating the terminal.
Important
This process should only be carried out by an AC2000 administrator with relevant permissions.
Checking the firmware version of the terminal
Press and hold the reader address
Figure 64 Checking the terminal firmware version
Loading the firmware onto the terminal(s)
1. Obtain the firmware pack from CEM and save to an accessible location on the network.
2. Log into the web pages by opening a web browser.
3. Enter the Server IP Address, e.g.
https://192.168.1.10
If the IP address has been changed from the default, enter the new IP address.
4. Enter the username and password.
5. Click Login.
6. Select AC2000 WEB | Reader Setup | Device Defrost
7. Click Browse and select the device image file (.pak) that is to be loaded.
Note
This image will be provided by CEM support and should be saved in a secure location.
8. Click Upload
9. Click OK.
The firmware version is
displayed for as long as
the press is held on the
reader address