User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
AC2000 Getting Started Guide
71
d. If no search criteria is entered, acknowledge the warning message that is
displayed by selecting Ignore.
e. Use the navigation arrows to locate the correct cardholder record from results
returned from the search (if required).
4. From the Database Toolbar, select Edit.
5. Click on the User Fields tab.
6. Delete the date entry in the Spare date1 field.
7. Select Save.
The random check prompt has now been cleared from the cardholder’s Personnel record.