User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
A2SE67-UG-0011-1
CHAPTER 7 : Door Modes
68
7.5.2 Configuring Image on swipe options
When Image on swipe is enabled and a cardholder presents a valid card at the emerald
reader, their cardholder details are displayed below the image. The details displayed are
determined by settings in the Configured application in AC2000.
1. From the AC2000 floatbar select Advanced Configuration | Configuration.
Figure 61 Configuring Image on swipe settings
2. Select the image_on_swipe_image_time field. This is the length of time the image will
display on the emerald reader and it is counted in milliseconds.
3. Type a Value e.g. 2500 (2.5 seconds).
4. Select the image_on_swipe_max_size field. This is the maximum image size in MB that
can be uploaded to display on the emerald reader. If the image is larger than this value, an
image placeholder is displayed. To ensure the image displays correctly, use a lower value
on slower network connections.
5. Type a Value e.g. 100000
6. Select the image_on_swipe_options field.
7. Type a Value. The default value is 01011111. The following table displays an example of
the default Value for the Image_on_swipe_options field. If a value is enabled it will
display when the user swipes a card at the emerald reader. If the value is disabled it will
not appear on the reader when a card is swiped.
Example of the deafult value for the Image_on_swipe_options field
Note
For more information on random checks, see section 7.5.2 Random Checks in this manual.
8. Select the image_on_swipe_random_msg field. This is the message that is displayed
when the cardholder swipes a valid card on the emerald reader when they have been
selected for a random check.
9. Type a Value e.g. send for drugs test.
RC COMP EXP JOB FN SN YN IMG
Random
check
Company Expiry
date
Job title First name Surname Confirmation
buttons
(Yes/No)
Image
display
010111 1 1
Disabled Enabled Disabled Enabled Enabled Enabled Enabled Enabled
Table 32: Example of the default value for the Image_on_swipe_options field
Image time
Max size
Options
Random
message