User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
AC2000 Getting Started Guide
67
7.5 Image on Swipe
Image on swipe is enabled/disabled within Pre Door Mode configuration. When a cardholder
swipes a card on an emerald reader which has Image on swipe enabled, the cardholder’s
image is displayed on the screen. A security guard monitoring the reader will confirm if the
image on screen resembles the cardholder and select the green tick button to authorise
access or the red X button to deny access.
Important
If Image on swipe and Checklists are both enabled, Checklists can no longer be used.
7.5.1 Enabling Image on swipe
From the AC2000 Floatbar select Device Configuration | Devices.
1. Select the device from the list on the left that is to be configured.
2. Select the Configuration tab.
3. Select the Common tab.
4. Select Pre Door Mode from the list.
Figure 60 Enabling/disabling Pre Door Mode
5. In the Configuration panel, select the Enable options tick box to enable Pre Door Mode.
Note
Enabling Pre Door Mode activates the associated Options.
6. From the Options, select the Image on swipe checkbox.
7. Press Save to save all changes.
Pre
Door
Mode
Image on swipe option