User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
A2SE67-UG-0011-1
CHAPTER 7 : Door Modes
66
Important
If using a third party logic controller to control multiple doors, the interlock principles remain the same. The spare
output opens on a valid special usage swipe and input 3 is opened on interlock terminals to trigger lock down.
Figure 59 Interlock no passenger access
message in passenger mode
5. The interlocked terminals with input 3
now open will lock down, preventing
access until the swiped door is closed
or the mode ended. Interlocked
terminals will display a no passenger
access message. Normal card access
is allowed.