User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
A2SE67-UG-0011-1
CHAPTER 7 : Door Modes
60
7.2 Control Post Mode
Control post mode places the terminal into a state where cards are swiped at a terminal with
no door equipment present. The terminal acknowledges the card but performs no other action.
Transaction logs are still maintained and all events can be observed in real time via the
Rolling Transaction Display application.
Note
All inputs may still be used as general purpose inputs and can be configured to trigger alarms
on the AC2000 software.
7.2.1 Software configuration for control post mode
1. From the Floatbar open Device Configuration | Devices.
2. Select the terminal from the list and open the Configuration panel.
3. Open the Common panel.
Figure 49 Configuring control post mode
Select Door
mode
Select
Control post
Click Save
Place a tick
in Enable
options