User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
TSR-IM-0045-1.6
CHAPTER 6 : The System Configuration Menu
54
Unit information
The Unit information section provides information regarding the status of the terminal.
6.3.3 Tests menu
The emerald terminal has built in tests that can be performed to check specific functionality.
Important
When contacting CEM support with any issues, these tests may be requested.
Figure 42 The tests menu
Info Description
Tamper sensor Describes the status of the internal tamper switch.
Run time Information about the running time and load of the terminal.
Main comms Indicates the status of the main comms.
Database engine Indicates the status of the database engine.
Local inputs Indicates the status of the local inputs such as door position, lock
sense etc.
Main reader Indicates the status of the emerald master terminal.
Door interface Indicates whether a door interface unit is currently connected to the
emerald terminal.
2nd reader Indicates whether an exit reader is currently connected to the terminal.
Table 31: Terminal unit information descriptions
Test the terminal inputs
Test network settings
Display card for testing
LCD brightness and
display settings