User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
emerald TS100/200/300 Installation Manual
53
Versions
The Versions information section details all hardware and software versions of the terminal.
Database
The Database information section details the information about the onboard card database.
Configuration
The Configuration menu provides information about terminal door modes.
Info Description
TSR Version Firmware version
UI Version User interface version
S/W Date Date of last firmware update
S/W Time Time of last firmware update on the S/W Date
H/W Version Version of the terminal hardware
H/W s/n Serial number of the terminal
Linux Linux kernel version, including date and time.
Qt Version of Qt library used by the UI.
Table 28: Terminal versions information descriptions
Info Description
CEM address The CEM reader address of the terminal.
Coldstart count Record of the number of times the terminal has been coldstarted.
Last coldstarted Date and time of the terminal’s last coldstart.
Card count Number of active cards held on the reader.
Last updated Date and time of the last database update from the server.
Trans all count Displays the number of buffered transactions and alarm events (in
offline mode). This is cleared when the terminal next goes online.
Trans card count Displays the number of buffered transactions only (in offline mode).
This is cleared when the terminal next goes online.
Last configured Displays the date and time that the terminal last received configuration
data from the server.
Table 29: Terminal database information descriptions
Info Description
Door mode Indicates the current door mode of the terminal. Standard Door,
Control Post, or Passenger mode.
PIN only TZ Displays a number to indicate which timezone is allocated as a PIN
only timezone.
Card only TZ Displays a number to indicate which timezone is allocated as a Card
only timezone
Door override TZ Displays a number to indicate which timezone is allocated as a Door
override timezone
Locked out TZ Displays a number to indicate which timezone is allocated as a Locked
out timezone
Table 30: Terminal configuration information descriptions