User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
TSR-IM-0045-1.6
CHAPTER 6 : The System Configuration Menu
50
Network
The Network menu is used to configure the network settings for the terminal.
Figure 39 The Network menu
Routing
The emerald terminal needs to be able to communicate with the Central Database Computer
(CDC) and the Real Time Computer (RTC). If a network is fragmented and the reader, CDC
and RTC are on different parts of the network, it may be necessary to route communications to
the RTC. In this situation, contact the site network administrator.
Figure 40 The Routing menu
The IP address assigned to
the terminal
The SubNet mask of the
network that the terminal is
connected to
The IP address of the
Gateway server where
appropriate
The IP address of the routing
network
The SubNet mask of the
routing network
The IP address of the
gateway server