User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
emerald TS100/200/300 Installation Manual
49
2. Select Configuration | Other | Diagnostic Pin.
3. Type the new PIN into the text field.
4. Click Save.
The system configuration menu has three sub-menus, each of which contains specific terminal
maintenance functions.
Figure 37 The system configuration menu
6.3.1 Device settings menu
The Device Settings menu is used to configure network and LCD settings.
Figure 38 The device settings menu
Configure terminal
settings
Access useful
information about the
terminal
Administer tests to
check terminal
functionality
Configure terminal
network settings
Configure routing
settings in disjointed
networks
Configure terminal
options