User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
TSR-IM-0045-1.6
CHAPTER 6 : The System Configuration Menu
48
6.2 Navigation
Menus on the Touchscreen terminal are accessed by touching the menu option to expand.
• Menus are expanded and closed by pressing the menu name or the arrow.
Figure 35 Expanding and closing reader menus
6.3 Accessing the system configuration menu
To access the configuration menu:
1. Slowly swipe a finger across the date/time from left to right.
2. When prompted to enter passcode type 6767000.
Note
See Accessing the Configuration Menu on page 34 for more details on passcodes..
Figure 36 Accessing the configuration menu
Configuring the passcode
The final four digits of the passcode can be changed to a site or reader specific code.
1. Open the Device application and select the reader.