User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
AC2000 Getting Started Guide
45
5.5.3 Assigning a remote application group to users
To assign a Remote Application Group to a cardholder:
1. Open AC2000SE | Enrolment | Personnel
2. Edit the cardholder’s record and select the appropriate listing from the Remote App.
Group drop down list.
Figure 33 Assigning Remote Application Group in Personnel
Note
If the Remote App Group drop down list is not visible in the Personnel interface, the option
has not yet been enabled. To enable this option, open the Configured application and scroll to
remote_app_group_enabled in the main pane. Type Y in the Value field and click Save. The
Remote App Group will now display as an option in Personnel records.
3. Click Save Changes button. The cardholder can now access the Remote Applications on
the terminal.
5.6 Next Steps
Congratulations! The emerald terminal is now fully installed. The remainder of the manual
details how to perform more advanced, complex tasks with the terminal including:
• Using the system configuration menu to view maintenance information and perform
terminal tests
• Configuring the terminal in additional modes such as passenger mode and control post.
• Upgrading terminal firmware
• Configuring device settings using the Device Settings Remote Application
Important
Advanced configuration of the terminal should only be carried out by users that have completed CEM AC2000
installer training.
Remote
App Group
drop down
list