User's Manual

AC2000 Getting Started Guide
41
5.4 Editing emerald Entries in AC2000
The following instructions are only required if the settings need to be edited during or after
terminal installation.
5.4.1 Editing device properties
1. Select the master device in the overview pane.
2. Make the required changes and click Save.
5.4.2 Editing a device input
1. Select the Input and the Input State that is to be edited from the Device Inputs
2. Click Save when changes have been completed.
Note
Save is only displayed when a change has been made.
5.4.3 Deleting a device input
1. Select the input from the Device Inputs list.
2. Click Delete.
Note
Care should be taken when deleting an input as no warning message will appear.
5.4.4 Input alarms
The following section contains input tables describing the set-up for each of the emerald
configurations outlined in this manual, including the AC2000 alarms that should be selected for
each sensor state where appropriate:
Input table for emerald with REX and emerald with third party read head:
Input number Input function Sensor state AED alarm
0 Door position Open Door forced
Closed Door closed
1 Lock position Open Lock not engaged
Closed Lock engaged
2 Request to exit No default
3 Spare / interlock No default
Table 22: emerald and REX / Third party read head input alarms