User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The Front Board
- 3.3 The Input/Output Board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit Switch
- 3.6 Configuration information
- 3.7 Terminal with 3rd Party Wiegand Read Head
- 3.8 Configuration information
- 3.9 Terminal with S610s Exit Reader
- 3.10 Terminal with DIU 210
- 3.11 Terminal with DIU 230
- 3.12 PoE+ Terminal with S610s Exit Reader
- 3.13 Tamper Detection on Reader Inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- Door Modes
- Appendix II: Device Settings Remote Application
- Appendix III: Broadcast and Timezone Priorities
- Appendix IV: Loading Card Definitions
- Appendix V: Configuring a Third Party Reader as a Master
9
Chapter 2
Mounting the Terminal
The emerald terminal can be mounted on a variety of standard electrical back boxes:
• UK single back box
• US single back box
• UK double back box mounted vertically
• 75mm VESA mount
2.1 Preparing for mounting
Care must be taken with the internal components when disassembling the terminal.
2.1.1 Recommended tools
• 3 mm flat head screwdriver for input / output connections and DC power
• Wire cutters and strippers
• Security hex screwdriver
Product CEM Product Code
Security screw driver handle HTO/000/001
Security screw driver bit HTO/000/000
Table 4: Security screwdriver product codes