User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 7 : S700 Operational Modes
88
Note: The feedback inputs, Input 0 and Input 1, in the table are optional. If they are not to be
used, Input 0 and Input 1 must be disabled.
Selecting Equipment mode in the Devices application
To select and enable Equipment mode for a device, complete the following steps:
Figure 62 Equipment Enable in the Properties tab
1. Launch the Devices application and select the device from the devices tree on the left.
2. Select the Properties tab and click Advanced View.
3. From the Configuration Properties pane, select Door mode.
4. To select Equipment enable mode, use the Options drop-down list to select Equipment.
5. In the Current Value field, set the value, and ensure the Enable Options check box is
selected.
6. Click Close and click Save.
Occupancy swipe
time
OST Pulsed mode activation time
Input 0 enable IPE(0) Used to enable activation feedback sense for
Master controller
Input 1 enable IPE(1) Used to enable activation feedback sense for
Exit controller
Configuration
item
Abbreviation Comment
Table 33: Equipment enable Timers