User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 7 : S700 Operational Modes
86
Figure 61 Passenger mode countdown on the swiped terminal
5. The interlocked terminals with input 3 now open locks down, preventing access until the
swiped door is closed or the mode ended. Interlocked terminals displays a no-passenger
access message. Normal card access is allowed.
Important: If using a third-party logic controller to control multiple doors, the interlock
principles remain the same. The spare output opens on a valid special usage swipe and input
3 is opened on interlock terminals to trigger lock down.