User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 1 : Introduction
8
1.1 Terminal user interface
Use the S700 interface to display information and enable user interaction to perform specific
functions. The screen displays the date, time, and the reader system address.
Date and time: The date, time, and day are permanently displayed.
Reader address: The reader address displays a unique five-digit number for each terminal on
the AC2000 system.
Figure 2 Terminal screen
1.2 Using the reader
The S700 is always in one of three modes:
• Door mode
• Free access
• Locked out mode
The home screen displays one of the following modes:
Reader
address
Date and time
display
Information
Network
status
display
indicator