User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 6 : The System Configuration Menu
74
Two-state input test
When an input is wired in a 2-state open and closed configuration, only the Open and Short
tests can be administered.
These states are as follows:
Open: The input is open
Short: The input is closed
Four-state input test
When an input has been wired in a 4-state configuration, all four input state tests can be
administered. For more information on configuration, see Configuration information on
page 36.
The following states are outlined as follows:
Open: Indicates a tamper cut condition
Open SW: The input is open
Closed: The input is closed
Short: Indicates a tamper short condition