User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 6 : The System Configuration Menu
70
Device Status: key 3
Use the Device status information section to view details about all the hardware and software
versions of the terminal.
Figure 44 Device status
Table 28: Device settings describes the fields in the Device status information window:
Database Status: key 4
Use the Database status information section to view detailed information about the onboard
card database.
Figure 45 Database status
Information Description
F/W Version Firmware version
F/W Date Date of firmware build
emWin Ver. Graphics library version
MCP Code Micro card processor part number
MD Code Main board part number
Unit Code Terminal part number
MCP s/n Micro card processor serial number
Unit s/n Terminal serial number
HW Build Terminal hardware build
Table 28: Device settings