User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
7
Chapter 1
Introduction
The S700 reader is an access terminal that provides secure door control and access monitoring at the
controlled location.
Used as part of the AC2000 system, the S700 reader controls access to restricted areas while also
giving you a range of information tools and applications at the door.
Figure 1 Photograph of the S700 terminal
Multi-colour
2.4 inch QVGA
LCD Screen
Context
status light
Speaker
sensitive
function keys
Capacitive
Keypad
bar