User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700 Installation Manual
69
Index: key 1
Use the index to return to the System Configuration Menu from any point in the menu system.
Network status: key 2
Use the Network status information section to view details about terminal network settings.
Figure 43 Network status
Table 27: Network status describes the fields in the Network status information window:
Information Description
IP address The IP address of the terminal
Subnet mask The subnet mask of the network hosting the terminal
Gateway The IP address of the gateway server
MAC address The MAC address of the terminal
Run time Total terminal run time since the system was last reset
CEM address The CEM reader address of the terminal
RTC IP The IP address of the RTC controlled the terminal
Exit reader Indicates if an exit reader has been enabled in AC2000
and if it is operating
DIU Indicates if a Door Interface Unit has been enabled in
AC2000 and if it is operating
OSDP head Indicates if an OSDP third-party head has been enabled in
the AC2000 system, and, if it is operating
Table 27: Network status