User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 6 : The System Configuration Menu
68
Figure 41 Diagnostic PIN
6. Into the Current Value field, type your new PIN and click Close.
7. To save the new PIN, click Save.
The System Configuration Menu has a 10-option list, each of which contains specific terminal
maintenance functions.
6.3.1 Device settings menu
Important: You must have the following information before contacting CEM Support with any
issues.
Figure 42 The system configuration menu
You can access the following settings through the System Configuration Menu. The following
settings are available:
Quit Settings: key 0
Use this setting to exit the System Configuration Menu and return to the terminal home screen.