User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
65
Chapter 6
The System Configuration Menu
The S700 utilises a Graphical User Interface (GUI) to access terminal functionality. At the basic level,
the screen is used to display messages regarding the current card swipe transaction. The more
advanced options allow the user to access information and reports that are relevant to them.
The S700 screen is a high quality, full colour, LCD screen. This is complimented by a capacitive touch
keypad, which is highly responsive in multiple weather conditions. The reader interface provides
access to a variety of tools, reports and information, such the as the following:
• Terminal configuration options
• Diagnostics and tests
• Software and hardware versions