User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 5 : AC2000 Software Configuration
58
6. Select Save.
The Exit reader associated with the master device is now configured as a third-party read head
and not an Exit reader.
5.3 Configuring devices
Use the Devices application to configure the inputs that are used to trigger alarms or events in
the AC2000 system.
5.3.1 Adding an input alarm
To add an input alarm to a device, complete the following steps:
1. Log on to the AC2000 Floatbar, click Device Configuration, and click Devices.
2. Select the device to configure from the overview pane on the left of the screen.
3. Select the Inputs tab on the main pane.
4. Click Enable and the Alarm and Broadcast drop-down lists became active.
Figure 36 Adding inputs dialog with example input 0 configuration
5. From the Alarm drop-down list, select an alarm type.
6. From the Broadcast drop-down list, select a broadcast type.
7. Select the alarm Type from the drop-down list.
8. In the Pulse Time box, set the time in seconds.
9. Click Save.
Alarm
type