User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700 Installation Manual
53
4.2.1 Setting the terminal IP address, gateway, and subnet mask
To set the IP address, gateway, and subnet mask of the terminal, complete the following steps:
1. To access the Network Settings menu, press key 5.
Figure 31 Configuring the terminal network settings
2. Select Next to highlight the relevant field.
3. Select Change to edit the selected field.
4. Enter the IP Address, Subnet mask and Gateway settings using the keypad. Press the
left function for a ‘.’
5. To exit settings, press key 0 and select Save to save the new settings, or Quit to discard
changes.