User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 1 : Introduction
16
Figure 6 Device status information
1.6 CEM S700 product codes
Contact CEM sales for further information.
Important: The correct card definitions must be loaded onto the CEM Central Database
Computer (CDC). See Loading card definitions on page 97. If you are using DESFire EV1
cards, which are sourced outside of CEM Systems, see the User Defined Keys manual to
configure card keys.
Using DESFire EV1
There are two different types of DESFire EV1 card. CEM Systems can provide a personalised
DESFire EV1 card with pre-defined attributes or non-personalised DESFire EV1 cards you can
use. If using non-personalised cards, refer to the User Defined Keys manual to configure card
keys.
Card Technology
Ethernet
Host
Serial Host Exit
FCC
Approved
Model
Prox, iCLASS / PicoPass
“Multi Tech”
RDR/700/003 RDR/701/003 RDR/702/003 QABS700PXV1-
00
MiFareDESFire / Prox
Duel-tech Reader
RDR/700/004 RDR/701/004 RDR/702/004 QABS700PXV1-
00
PicoPass RDR/700/006 RDR/701/006 RDR/702/006 QABS700V1-00
DESFire RDR/700/007 RDR/701/007 RDR/702/007 QABS700V1-00
iCLASS RDR/700/008 RDR/701/008 RDR/702/008 QABS700V1-00
Table 3: List of CEM S700 product codes