User's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Guide to setting up S610S
- 3 Connecting an S610S Master Reader
- 3.1 Open the S610 reader case
- 3.2 S610S Master Reader 12V Power and Data connections
- 3.3 Extra settings required, made on the reader
- 3.4 Addressing an S610S master reader
- 3.5 S610S Connecting Master Reader Inputs
- 3.6 Monitoring Inputs for Cable Tampers
- 3.7 Using an external read head
- 3.8 S610S Lock and spare output relay connections
- 4 Connecting an S610S to an Exit Reader
- 5 Connecting an S610S to a DIU
- 6 AC2000 Devices Application tasks
- 7 Door Modes
- 8 Interlock
- 9 Other AC2000 software configurations
- 10 S610S onboard diagnostic mode
- 11 Appendix
S610S Manual - Hardware Installer Manual - Version 1.8
38
AC2000 – Configuring Turnstile Mode
TIME CONFIGURATION
NOTE: For Fast Pulse Turnstile mode, Lock open time two MUST be set to Zero.
Pulse Turnstile, one second or more pulse output
Correct for Firmware revision B1.00.023. LOT2 indicates “Lock open time 2”
Fast Pulse Turnstile, fixed half second pulse output.
Correct for Firmware revision B1.00.023
LOT2 indicates “Lock open time 2” which MUST be set to Zero for Fast Pulse operation.