User's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Guide to setting up S610S
- 3 Connecting an S610S Master Reader
- 3.1 Open the S610 reader case
- 3.2 S610S Master Reader 12V Power and Data connections
- 3.3 Extra settings required, made on the reader
- 3.4 Addressing an S610S master reader
- 3.5 S610S Connecting Master Reader Inputs
- 3.6 Monitoring Inputs for Cable Tampers
- 3.7 Using an external read head
- 3.8 S610S Lock and spare output relay connections
- 4 Connecting an S610S to an Exit Reader
- 5 Connecting an S610S to a DIU
- 6 AC2000 Devices Application tasks
- 7 Door Modes
- 8 Interlock
- 9 Other AC2000 software configurations
- 10 S610S onboard diagnostic mode
- 11 Appendix
S610S Manual - Hardware Installer Manual - Version 1.8
37
Configure in AC2000 Devices application if an Alarm is required.
IP1 Input Used to record Turnstile position after Readhead1 cardswipe
Configure in AC2000 Devices application if an Alarm is required
IP2 Input REX Button (Head0 side of Turnstile, triggers Relay0)
(Optional)
IP3 Input REX Button (Head1 side of Turnstile, triggers Relay1)
(Optional)
Relay0
Output Dry contact relay. Note the Relay changes state on reader power up.
Choice of Normally Open or Normally Closed contacts.
Release signal to Turnstile for Direction0
Actioned by a valid cardswipe on Readhead0
Relay1
Output Dry contact relay. Note the Relay changes state on reader power up..
Choice of Normally Open or Normally Closed contacts.
Release signal to Turnstile for Direction1
Actioned by a valid cardswipe on Readhead1