User's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Guide to setting up S610S
- 3 Connecting an S610S Master Reader
- 3.1 Open the S610 reader case
- 3.2 S610S Master Reader 12V Power and Data connections
- 3.3 Extra settings required, made on the reader
- 3.4 Addressing an S610S master reader
- 3.5 S610S Connecting Master Reader Inputs
- 3.6 Monitoring Inputs for Cable Tampers
- 3.7 Using an external read head
- 3.8 S610S Lock and spare output relay connections
- 4 Connecting an S610S to an Exit Reader
- 5 Connecting an S610S to a DIU
- 6 AC2000 Devices Application tasks
- 7 Door Modes
- 8 Interlock
- 9 Other AC2000 software configurations
- 10 S610S onboard diagnostic mode
- 11 Appendix
S610S Manual - Hardware Installer Manual - Version 1.8
33
7.6 Passenger-staff exit mode
PASSENGER-STAFF EXIT MODE
Passenger-staff exit is the newly created door mode. This mode is based on “Passenger Mode” and
includes the new features described below. Minimum reader firmware B1.0.0.43 for S600E and
B1.0.0.49 for S600S is needed and a patch to AC2000 6.1 or earlier is needed.
Passenger Mode
Passenger-Staff Exit Mode
REX
REX starts Passenger Access Mode and
door is held for extended door open time
Door is held for normal door open time.
Card swipe on exit
Reader
No difference with swipe on master reader.
Card swipe on Exit reader is also able to
start Passenger Access
Card swipe on Exit reader is not able to start
Passenger Access working as per normal card
swipe.
Full interlock
Supported since version 39
YES
FULL INTERLOCK FEATURE
Please refer to “Passenger mode full interlock.doc”
Air-Bridge with Passenger-Staff exit mode
INTERLOCKING
Door interlock feature is active when Reader is in Lobby mode. When “Normal input” of input-3
configuration is cleared and Reader is in Passenger-staff exit mode, Lobby mode will be
automatically activated.
As input-3 is active, when reader is interlocked, reader may disable its head and prevent any card
swipe depending on the configuration status - “No access on interlock” in Second swipe Action
(0x04).
When “No access on interlock” configuration is cleared, Reader works as described in the table
below.
Present states are listed under the Air-Bridge state column and the state that any of the three door
sets may be switched to is listed under the relevant door type column.
Door Interlocking, Privilege Card
Air bridge State
Arrival Door
Departure A
Departure B
Idle state
Passenger or Staff Access
Passenger or Staff Access
Passenger or Staff Access
Arrival door passenger
access
Cancel Mode or Restart
Mode
Staff Access Only Staff Access Only
Departure door A passenger
access
Staff Access Only
Cancel Mode or Restart
Mode
Passenger or Staff Access
Departure door B passenger
access
Staff Access Only Passenger or Staff Access
Cancel Mode or Restart
Mode
Door Interlocking, Non-Privilege Card
Air bridge State
Arrival Door
Departure A
Departure B
Idle state
Staff Access Only
Staff Access Only
Staff Access Only
Arrival door passenger
access
No action, Door is already
open
Staff Access Only Staff Access Only
Departure door A passenger
access
Staff Access Only
No action, Door is already
open
Staff Access Only
Departure door B passenger
access
Staff Access Only Staff Access Only
No action, Door is already
open