User's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Guide to setting up S610S
- 3 Connecting an S610S Master Reader
- 3.1 Open the S610 reader case
- 3.2 S610S Master Reader 12V Power and Data connections
- 3.3 Extra settings required, made on the reader
- 3.4 Addressing an S610S master reader
- 3.5 S610S Connecting Master Reader Inputs
- 3.6 Monitoring Inputs for Cable Tampers
- 3.7 Using an external read head
- 3.8 S610S Lock and spare output relay connections
- 4 Connecting an S610S to an Exit Reader
- 5 Connecting an S610S to a DIU
- 6 AC2000 Devices Application tasks
- 7 Door Modes
- 8 Interlock
- 9 Other AC2000 software configurations
- 10 S610S onboard diagnostic mode
- 11 Appendix
S610S Manual - Hardware Installer Manual - Version 1.8
29
Master Pin only - During the Door Time Zone only the Key Pad is enabled. The Master read head is
disabled. Key pad must be enabled using the reader’s onboard diagnostic menu.
Slave Pin only - During the Door Time Zone the Exit read head is disabled the Key pad must be
enabled using the reader’s onboard diagnostic menu.
Master card only - During the Door Time Zone only the master read head is enabled.
Slave card Only - During the Door Time Zone only the Exit read head is enabled
Extended Mode - MUST be checked to enable any of the above setting to take place.