User's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Guide to setting up S610S
- 3 Connecting an S610S Master Reader
- 3.1 Open the S610 reader case
- 3.2 S610S Master Reader 12V Power and Data connections
- 3.3 Extra settings required, made on the reader
- 3.4 Addressing an S610S master reader
- 3.5 S610S Connecting Master Reader Inputs
- 3.6 Monitoring Inputs for Cable Tampers
- 3.7 Using an external read head
- 3.8 S610S Lock and spare output relay connections
- 4 Connecting an S610S to an Exit Reader
- 5 Connecting an S610S to a DIU
- 6 AC2000 Devices Application tasks
- 7 Door Modes
- 8 Interlock
- 9 Other AC2000 software configurations
- 10 S610S onboard diagnostic mode
- 11 Appendix
S610S Manual - Hardware Installer Manual - Version 1.8
21
Any 4-State inputs must be configured in the AC2000 Devices application as 4 state inputs if AED alarms from these
inputs are required. See fig 4.2, note 4 state check option.
+
N/A Not Applicable – these are system inputs, no user configuration is required.
Set up the S610S with DIU
The installer must also set the reader to communicate with the DIU using the reader’s onboard
keypad. A Master serial reader does not automatically connect to the DIU after receiving its
configuration set on the AC2000 workstation Devices Application.
Use the reader’s keypad to access the diagnostic menu to address an S610S.
Other S610S reader settings are also locally made at the reader using the keypad: an Exit Reader
and/or a DIU must also be set as present using this method. Inputs and outputs configured remotely
from an AC2000 workstation.
Enter followed by the reader PIN code. (Factory Default PIN 0000).
Default Reader PIN codes may have been changed or disabled by your System Administrator.
If incorrectly entering a pin, wait 5 seconds before trying again, to allow for timeout.
On the master reader, use the key to navigate to the Configuration menu.
Press key, then the key to navigate to the AUX Device(s) menu
Select DIU or NO DIU accordingly.
After the setting has been accepted, press repeatedly until the reader exits diagnostic mode.
Devices Application - Setting the S610S Exit reader and DIU configuration
A Master reader does not automatically connect to the Exit Reader or DIU.
The Master reader’s configuration must be updated to include an Exit Reader on the AC2000
workstation Devices Application.
For
Device type, select S600+DIU+Slave if a DIU and Exit reader are present.
Local Sounder output
A S610s with DIU and slave will use the local sounder for door forced, held, etc only when the
sounder action configuration is enabled locally in the reader configuration menu.
For more information on DIU and Backplane please consult the DIU with Backplane manual.