User's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Guide to setting up S610S
- 3 Connecting an S610S Master Reader
- 3.1 Open the S610 reader case
- 3.2 S610S Master Reader 12V Power and Data connections
- 3.3 Extra settings required, made on the reader
- 3.4 Addressing an S610S master reader
- 3.5 S610S Connecting Master Reader Inputs
- 3.6 Monitoring Inputs for Cable Tampers
- 3.7 Using an external read head
- 3.8 S610S Lock and spare output relay connections
- 4 Connecting an S610S to an Exit Reader
- 5 Connecting an S610S to a DIU
- 6 AC2000 Devices Application tasks
- 7 Door Modes
- 8 Interlock
- 9 Other AC2000 software configurations
- 10 S610S onboard diagnostic mode
- 11 Appendix
S610S Manual - Hardware Installer Manual - Version 1.8
19
5
5
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
n
n
g
g
a
a
n
n
S
S
6
6
1
1
0
0
S
S
t
t
o
o
a
a
D
D
I
I
U
U
For more information on the DIU please consult the DIU manual.
5.1 Connecting an S610S to a DIU210
Power & RS485 serial connections to a Master Reader
Power & RS485 serial connections to a Master Reader and RS485 channel connections to and from
a DIU210 backplane
ENSURE THE EXIT READER AND THE DIU ARE ENABLED
USING THE MASTER READER’S KEYPAD OPTIONS MENU
Note: If the Exit reader fails to read a valid card (when the Master reader reads successfully)
ensure the Auxiliary Devices, Exit Reader and DIU are enabled, using the Diagnostic keypad menu,
and that the Reader with Exit and DIU is correctly configured in the Devices application. See Setup
the S610S with DIU below.