User's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Guide to setting up S610S
- 3 Connecting an S610S Master Reader
- 3.1 Open the S610 reader case
- 3.2 S610S Master Reader 12V Power and Data connections
- 3.3 Extra settings required, made on the reader
- 3.4 Addressing an S610S master reader
- 3.5 S610S Connecting Master Reader Inputs
- 3.6 Monitoring Inputs for Cable Tampers
- 3.7 Using an external read head
- 3.8 S610S Lock and spare output relay connections
- 4 Connecting an S610S to an Exit Reader
- 5 Connecting an S610S to a DIU
- 6 AC2000 Devices Application tasks
- 7 Door Modes
- 8 Interlock
- 9 Other AC2000 software configurations
- 10 S610S onboard diagnostic mode
- 11 Appendix
S610S Manual - Hardware Installer Manual - Version 1.8
9
2
2
Q
Q
u
u
i
i
c
c
k
k
G
G
u
u
i
i
d
d
e
e
t
t
o
o
s
s
e
e
t
t
t
t
i
i
n
n
g
g
u
u
p
p
S
S
6
6
1
1
0
0
S
S
Mount Reader, make good all device connections,
I/ Os etc and connect to PSU
Connect an Exit Reader if required
Using the reader’s keypad
1. Address the S
610S reader
2. Enable Aux Devices if present eg Exit Reader and/ or DIU
3. Enable Card Definition and read head
Ensure RS485 Serial Comms from a Controller will reach
the mounting point and that a 12V power supply is available.
Configure new Door on access control system using
AC2000 Workstation Devices application
Access Level and Map Administration applications
Add the new Device to the Map
Chapter 3
Chapter 4
Chapter 6
AC2000 User Guide
AED chapt er
Configure Inputs on AC2000 Workstation
Devices application for AED Display
Chapter 9
Connect a DIU if required
Chapter 5
Interlocking
Chapter 8
Door Mode options
Chapter 7