User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Glossary InfoProx Entry
Tamper Sensor: A light-sensing device on the back of the reader that sounds an alarm
when the unit has been tampered with.
Time zone end: Specifies the end time for the time zone type.
Time zone start: Specifies the start time for the time zone type.
Time zone type: Specifies the access type. For example, GIN, Door override, or Card
only.
Transaction: Record of an event logged into a report file. Examples of events are alarms
or actions, such as door access, door forced, or door held.
Unlock time: See Door strike time.
Unsupervised input: An input that detects two states: normal and alarm.
Upload: From the software backup utility on a computer, the user can upload data to the
reader. The reader is the primary and controlling device from which you can download
data to a computer.
72 Software House