User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Technical Description
The LCD Panel
The two-line by 16-character Liquid Crystal Display (LCD) provides useful card
swipe and diagnostic information, and is vital for configuring the reader. Normally,
the reader will display a message, similar to the following example:
InfoENTRY 16:30
Present card
The address and status of the reader are displayed on the top line, while the result
of the card swipe and the current time are displayed on the bottom line of the LCD.
LCD Contrast Control
The LCD contrast can be adjusted by using the Reader Setup program.
Note See Section 7: Installation; “Setup procedure for the InfoProx Entry
reader.”
Batteries
A PCB-mounted 3.6V rechargeable Lithium battery provides backup power for the
RAM IC. The battery ensures that the database is maintained, even if the reader is
disconnected from the main power supply.
Circuitry is provided to permit trickle charging of this battery from the reader
supply.
Note The charging process for a discharged battery may take approximately five
days.
Software House 63