User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Technical Description InfoProx Entry
Card Technology
The Software House InfoProx Entry reader is manufactured to use proximity
technology, under license from HID Corporation. The following card types are
supported:
· ISOProx® ll Card
· ProxCard™ Plus Card
· ProxCard® ll Card
· ProxKey™ ll Fob
The Keypad
The 12-way keypad on the front of the reader is an integral part of the reader’s
functionality. Cardholders must enter their Personal Identification Number (PIN)
after a valid card swipe, before access is granted in normal mode.
The LEDS
The three high intensity LEDs (red, green, and amber) are displayed at the front of
the reader. LEDs indicate outcomes of card swipes. Possible responses to card
swipes are as follows:
LCD Display LED
Card Valid Green
Invalid Card Red
Not In System Red
Error Reading Card - Retry Red
Close Door Red
Retry PIN Number Amber
Time Zone Set Amber Blinking
Table 2: Card Transaction Displays
62 Software House