User's Manual

InfoProx Entry Technical Description
Exit Readers
Each reader can service an additional exit reader, which can be used on the inner
side of a secure access point. The InfoProx Entry reader can have one full exit
reader with an LCD and a keypad.
The full exit reader is an InfoProx Entry reader, which differs from the entry in that
it does not have internal RAM and therefore cannot hold card IDs and status data.
The information is held in the attached entry unit’s database.
Inputs and Outputs
Each reader monitors up to four inputs: input 0 monitors door position; input 1
monitors lock status; input 2 is for push button; and input 3 is a spare unit.
Each reader has one relay, rated at 30VDC @ 5 Amps. For normal door mode,
this relay is reserved for door strike. For example, the relay automatically fires on a
valid card swipe. Each reader has a single dry contact relay that provides a control
signal to external units.
The relay is energized through a discrete, EEPROM-controlled switching circuit,
which determines the Relay Idle State.
The number of inputs and outputs can be extended. If the reader is connected to a
Door Interface Unit (DIU), conditions are monitored from the DIU directly, thus
freeing up all four inputs and one output on the reader.
The Read-Head
The Software House InfoProx Entry reader is manufactured to use proximity
technology, licensed from HID Corporation. The following read ranges are
supported:
· ProxCard® ll Card: 10cm (4")
· ISOProx® ll Card: 9cm (3.6")
· ProxCard™ Plus Card: 6cm (2.4")
· ProxKey™ ll Fob: 4cm (1.6")
Software House 61