User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Diagnostic Routine
If an exit reader is connected to the entry reader, the diagnostic routine tests the
exit’s LED’s and keypad in the appropriate sequence, as explained in the
Installation Guide. When the entry reader is in diagnostic mode, if there is an exit
reader connected, the routine would be as follows: entry tested, then exit reader
tested, in sequence through the routine – such as entry LED’s, exit LED’s, and so
on.
Final Diagnostic Checklist
1. Use the InfoProx Reader diagnostic routine to check the functionality of the reader.
Present a valid card to ensure that the reader performs as required.
2. Secure the adapter plate to the containment box, position the reader, and tighten the
two pin-hex security screws ensuring that they are not over tightened.
Note To prevent light from triggering the tamper sensor, ensure that there are no
gaps around the unit.
3. Fit the cover buttons firmly in place over the screws.
Note To remove the cover buttons, use a screwdriver on the outer edges to lift the
covers.
Software House 59