User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Diagnostic Routine InfoProx Entry
7. DIAGNOSTIC ROUTINE
Once the InfoProx Entry reader has been set up and configured, check the current setup
status and operational functions of the reader by starting the diagnostic routine. The
diagnostic routine menu also allows you to change the reader setup, as was explained in
section 4.
Initiating The Diagnostic Routine
To run the diagnostic routine
1. Enter (# 0 Ù ), the administration key sequence.
2. Enter the password.
The following screen appears.
O-Del, 1-Add
2-Find, 3-Config
3. Press Ù to open the second setup screen.
4-Diag, 2-Pword
6-Backup,
4. Press 4 to open the following screen.
InfoProx ENTRY
[Build 0.155]
Note The first part of the diagnostic routine is automatic and will
test the reader's functionality.
There are several screens that will appear and then end with the
following screen.
Configure Rdr ?
No Ù Yes #
5. Press Ù to start the diagnostic routine. The display scrolls through the
various screens.
By pressing #, the user enters the reader setup
mode, as shown in section 5. If setup has already
been done, then bypass this mode by pressing Ù to
enter the read-only diagnostic sequence.
56 Software House