User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Card Management
PC Backup
Note In addition to the following instructions, see the Software Utility Manual for
more information about this application.
To access the software utility backup
1. Press 6 to access the Software Utility Backup tool.
4-Diag, 5-Pword
6-Backup,
The following prompt appears:
CONNECTING TO PC
If the following prompt appears the reader has not connected to the
workstation and the backup utility is not operating.
NO CONNECTION
Note Uploading a new database from a PC overwrites the current
database in the reader
Note To use the Backup option, the unit must be connected through an RS485-
RS232 converter that is connected to the PC, running the PC/software
backup program.
Software House 55