User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
Card Management InfoProx Entry
To search for all card records from the lowest number
1. Press 2 on the Find prompt, as shown below.
0-HSTMP, 1-SWIPE
2-ALL CARDS
This changes the screen to the following:
From 1st-1
Last-9, HstNo-2
2. Press 1 (From 1st) on the Search All Cards screen to display all cards
individually by system number, starting with the card with the lowest
system number, as shown in the following example:
1 Dn 2 Up000001
No:00004959 1234
3. Use keys 1 and 2 to step through the database (down and up,
respectively)--or 1 down, 2 up. The associated PIN and hotstamp
number displays for each card.
Note In the display, as shown in step 2, 000001 is a sequential
number indicating the position of the card in the database,
starting from the card with the lowest system number (being
allocated 000000) up to the total number of cards in the
database.
52 Software House