User's Manual
Table Of Contents
- Important Safety Information
- Introduction
- Getting Started
- InfoProx Hardware Installation
- Configuring the Door Control Unit
- First Time Access to the Administration Menu
- Accessing the Administration Menu after Password Setup
- Getting to know the configuration setup
- Configuring the reader
- Configure Current Time
- Configure Time Zone
- Time zone types
- Configure Inputs
- Doorstrike Time
- Door Close After Time
- GIN Configuration
- Site Code
- Door Control Unit Diagnostic Screen Set Up
- Contrast
- Door Mode
- Keypad Enable / Disable
- Exit Configuration
- Relay Idle State
- Card Management
- DIAGNOSTIC ROUTINE
- InfoProx Technical Description
- Glossary
InfoProx Entry Card Management
To find a card by swipe (option 1)
1. Press 2 on the Administration menu to search for a specific card in the
database. Cards are stored in order of the encoded system card number.
The following prompt appears, presenting search options.
0-HSTMP, 1-SWIPE
2-ALL CARDS
2. Press 1.
This action enables the search for the encoded card number and
associated PIN stored in the reader database by presenting the card to
the reader.
3. Present a card to the reader within the appropriate read range for that
card type. When the unit finds the card record, the system number,
hotstamp number and PIN appear, as follows.
SYS No: 00135F
No.:00004559 1234
By using the swipe method, several cards can be
presented in turn. If an incorrectly formatted card is
used in the transaction, BAD CARD is displayed. If a
card transaction does not occur before the timeout
period elapses, the display returns to the
Administration menu prompt.
Pressing # at any time returns the display to the Administration menu
prompt.
Software House 51